LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> LC 500 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Starter >> Engine Starting System - Service Information (Convertible) >> Starter >> Installation [07/2020 - 05/2023] >> Procedure

Installation [07/2020 - 05/2023]: Procedure

  1. INSTALL FLYWHEEL HOUSING SIDE COVER 
    1. Install the flywheel housing side cover as shown in the illustration.
  2. INSTALL STARTER ASSEMBLY 
    1. Install the starter assembly with the 2 bolts.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Install the terminal cover with the nut A.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the starter wire with the nut B.

      Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf) 

    4. Close the terminal cover.
    5. Connect the starter assembly connector.
  3. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR 
    1. Install the No. 3 exhaust manifold heat insulator with the 3 bolts.

      Torque: 11.5 N*m (117 kgf*cm, 8 ft.*lbf) 

  4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH 

    Refer to INSTALLATION [07/2020 - ]

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 

    Refer to INSTALLATION [07/2020 - 05/2023]

  6. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [07/2020 - 05/2023]

scientia non olet · About LEMON Manuals