Removal [07/2020 - ]: Procedure

Refer to REMOVAL [07/2020 - 05/2023] , or refer to REMOVAL [05/2023 - ]

1. Disconnect the connector.
2. Detach the claws and remove the front corner ultrasonic sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Before removing the sensor, make sure to mark the sensor and front bumper cover so that each sensor can be returned to its original position.

1. Disconnect the connector.
2. Detach the claws and remove the front center ultrasonic sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Before removing the sensor, make sure to mark the sensor and front bumper cover so that each sensor can be returned to its original position.

HINT: 

• Perform the following procedure only when replacement of a front corner ultrasonic sensor retainer is necessary.
• When removing the front corner ultrasonic sensor retainer, heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light.

1. Heat the front bumper assembly and front corner ultrasonic sensor retainer using a heat light at the specified temperature for 3 to 5 minutes.
   WARNING:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Heated Part
   *b	Heat Light

   • Do not touch the heat light and heated parts.
   • Touching the heat light may result in burns.
   • Touching heated parts for a long time may result in burns.

   Standard

   Item	Temperature
   Front Bumper Assembly	20 to 30°C (68 to 86°F)
   Front Corner Ultrasonic Sensor Retainer

2. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Remove the front corner ultrasonic sensor retainer.