Installation [12/2023 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Arrow

   -

   -

   1. Install the rear stabilizer bush from the rear stabilizer bar bracket.
   2. Install the rear stabilizer bar and 2 rear stabilizer bar brackets with the 4 nuts.

      Torque: 97 N.m (989 kgf/cm, 72 ft.lbf) 

      HINT: 

      • Install the rear stabilizer bar bracket as shown in the illustration.
      • Tighten the nuts in the following sequence: Temporarily install in the order of A to tighten in the order of B to A.

Torque: 96 N.m (979 kgf/cm, 71 ft.lbf) 

1. Use the same procedure described for the LH side.

Torque: 75 N.m (765 kgf/cm, 55 ft.lbf) 

1. Use the same procedure described for the LH side.

Refer to INSTALLATION [12/2023 - ]