Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door belt moulding assembly LH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function when Necessary Procedures are not Performed	Link
Rear door glass sub-assembly LH Rear door glass sub-assembly RH Rear door glass run LH Rear door glass run RH	Initialize power window control system	Auto up and down function Jam protection function Catch protection function Remote control function Key-linked function Wireless transmitter-linked function Key-off operation function Window open warning function	Refer to REGISTRATION [12/2023 - ]

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

Learning completes when vehicle is driven

Effect/Inoperative Function when Necessary Procedures are not Performed	Necessary Procedures	Link
Lighting system (EXT) Cornering lights	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.	Refer to INITIALIZATION [12/2023 - ]
Front camera system		Refer to INITIALIZATION [12/2023 - ]

Learning completes when vehicle is operated normally

Effect/Inoperative Function when Necessary Procedures are not Performed	Necessary Procedures	Link
Power back door system	Fully close the back door by hand. HINT: Initialization is not necessary if the above procedures are performed while the back door is closed.	Refer to INITIALIZATION [12/2023 - ]
Air conditioning system	After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized.	-

Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.

COMPONENTS (REMOVAL)

Fig 1: Rear Door Belt Moulding Removal Components

Procedure		Part Name Code
1	DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL	-	See step 1	-	-
2	REAR DOOR UPPER TRIM COVER LH	67786D	See step 2	-	-
3	REAR DOOR ARMREST COVER LH	74222C	See step 3	-	-
4	COURTESY LIGHT ASSEMBLY	81230	See step 4	-	-
5	REAR DOOR TRIM BOARD SUB-ASSEMBLY LH	67604	-	-	-
6	REAR DOOR INNER GLASS WEATHERSTRIP LH	68174	-	-	-
7	REAR DOOR REAR BELT SEAL LH	68199	-	-	-
8	REAR DOOR SERVICE HOLE COVER LH	67842E	See step 8	-	-
9	REAR DOOR FRAME GARNISH LH	67674A	-	-	-
10	REAR DOOR GLASS RUN LH	68152C	-	-	-
11	REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH	67408E	See step 11	-	-
12	REAR DOOR REAR WINDOW FRAME MOULDING LH	75766C	-	-	-
13	REAR DOOR QUARTER WINDOW GLASS LH	68124C	-	-	-
14	REAR DOOR GLASS SUB-ASSEMBLY LH	68104	See step 14	-	-
15	REAR DOOR BELT MOULDING LH	75722A	See step 15	-	-

*1	BUTYL TAPE	-	-
•	Non-reusable part	-	-