Inspection [12/2023 - ]: Procedure
- INSPECT POWER LIFT STEP ASSEMBLY LH
- Check that the motor gear rotates smoothly as follows.NOTE:
Do not apply positive (+) auxiliary battery voltage to any terminals except terminal 1 and 2 to avoid damaging the pulse sensor inside the motor.
*1 Motor Gear *a Component without harness connected
(Power Lift Step Assembly LH)Turn in this Direction (1) Turn in this Direction (2) OK
Tester Connection Specified Condition Auxiliary battery positive (+) - L14-2 (STW1)
Auxiliary battery negative (-) - L14-1 (DPL1)Motor gear rotates turn in Direction (1) Auxiliary battery positive (+) - L14-1 (DPL1)
Auxiliary battery negative (-) - L14-2 (STW1)Motor gear rotates turn in Direction (2) - If the result is not as specified, replace the power lift step assembly LH.
WARNING:Reset the power lift step assembly LH (initialize the pulse sensor) after installing the power lift step assembly.
- Check that the motor gear rotates smoothly as follows.
- INSPECT POWER LIFT STEP ASSEMBLY RH
- Check that the motor gear rotates smoothly as follows.NOTE:
Do not apply positive (+) auxiliary battery voltage to any terminals except terminal 1 and 2 to avoid damaging the pulse sensor inside the motor.
*1 Motor Gear *a Component without harness connected
(Power Lift Step Assembly RH)Turn in this Direction (1) Turn in this Direction (2) OK
Tester Connection Specified Condition Auxiliary battery positive (+) - K19-2 (STW2)
Auxiliary battery negative (-) - K19-1 (DPL2)Motor gear rotates turn in Direction (2) Auxiliary battery positive (+) - K19-1 (DPL2)
Auxiliary battery negative (-) - K19-2 (STW2)Motor gear rotates turn in Direction (1) - If the result is not as specified, replace the power lift step assembly RH.
WARNING:Reset the power lift step assembly RH (initialize the pulse sensor) after installing the power lift step assembly RH.
- Check that the motor gear rotates smoothly as follows.
