Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front door adjustment are shown below.

HINT: 

• When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
  • Learning completes when vehicle is driven

    Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
    Lighting system (EXT) Cornering lights	Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.	Refer to INITIALIZATION [12/2023 - ]
    Front camera system

  • Learning completes when vehicle is operated normally

    Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
    Power back door system	Fully close the back door by hand. HINT:  Initialization is not necessary if the above procedures are performed while the back door is closed.	Refer to INITIALIZATION [12/2023 - ]
    Air conditioning system	After the ignition switch is turned to ON, the servo motor standard position is recognized.	-

• Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

  *a	Centering Bolt
  *b	Standard Bolt

• The specified torque for standard bolts is shown in the standard bolt chart.

  Refer to SPECIFIED TORQUE FOR STANDARD BOLTS [12/2023 - ]

• Use the same procedure for the LH side and RH side.
• The following procedure is for the LH side.