Entire Combination Meter does not Operate [12/2023 - ]: Procedure

1. Disconnect the E4 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E4-1 (EP) - Body ground	Always	Below 1 Ω
   E4-2 (ES) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   E4-6 (IG+) - Body ground	Ignition switch off	Below 1 V
   	Ignition switch ON	11 to 14 V
   E4-5 (B) - Body ground	Always	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR