DTC B1500-13: Fuel Sender Circuit Open [12/2023 - ]: Procedure

Refer to INSPECTION [12/2023 - ]

Result

Result: 

NG 

REPLACE FUEL SENDER GAUGE ASSEMBLY. Refer to  REMOVAL [12/2023 - ] 

Result: 

OK 

See step  2

Pre-procedure1

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the fuel suction plate sub-assembly.

   Refer to DISASSEMBLY [12/2023 - ]

   Procedure1

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   N3-1 (FV) - B-1	Always	Below 1 Ω
   N3-2 (FE) - B-2	Always	Below 1 Ω
   N3-3 (FR) - B-3	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

   Post-procedure1

3. None

Result: 

NG 

REPLACE FUEL SUCTION PLATE SUB-ASSEMBLY. Refer to  DISASSEMBLY [12/2023 - ] 

Result: 

OK 

See step  3

Pre-procedure1

1. Disconnect the N3 fuel suction plate sub-assembly connector.
2. Disconnect the E5 combination meter assembly connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   N3-3 (FR) - E5-7 (FR)	Always	Below 1 Ω
   N3-2 (FE) - E5-25 (FE&B)	Always	Below 1 Ω
   N3-1 (FV) - E5-23 (FV)	Always	Below 1 Ω
   N3-3 (FR) or E5-7 (FR) - Other terminals and body ground	Always	10 kΩ or higher
   N3-2 (FE) or E5-25 (FE&B) - Other terminals and body ground	Always	10 kΩ or higher
   N3-1 (FV) or E5-23 (FV) - Other terminals and body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2023 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR