Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Combination meter assembly | Update ECU security key | Vehicle control history (RoB) are stored | Refer to UPDATE ECU SECURITY KEY [12/2023 - ] |
| Software update | - | Refer to REGISTRATION [12/2023 - ] |
COMPONENTS (REMOVAL)
| Procedure | Part Name Code | ||||
|---|---|---|---|---|---|
| 1 | CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM | - | - | - | See step 1 |
| 2 | INSTRUMENT SIDE PANEL LH | 55318C | See step 2 | - | - |
| 3 | LOWER INSTRUMENT PANEL FINISH PANEL | 55432B | - | - | - |
| 4 | NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION | 55449F | See step 4 | - | - |
| 5 | NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION | 55448D | See step 4 | - | - |
| 6 | LOWER INSTRUMENT PANEL | 55312 | - | - | - |
| 7 | SHIFT LEVER KNOB SUB-ASSEMBLY | 33504F | See step 7 | - | - |
| 8 | LOWER INSTRUMENT PANEL SUB-ASSEMBLY | 55303B | - | - | - |
| 9 | UPPER CONSOLE PANEL SUB-ASSEMBLY | 58804A | See step 9 | - | - |
| 10 | CENTER INSTRUMENT CLUSTER FINISH PANEL | 55412D | - | - | - |
| 11 | NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY | 55670 | See step 11 | - | - |
| 12 | INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY | 55410C | - | - | - |
| 13 | RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET | - | See step 13 | - | - |
| 14 | INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY | 55404D | - | - | - |
| 15 | NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY | 55650 | - | - | - |
| 16 | COMBINATION METER ASSEMBLY | 83100 | - | - | - |
| *A | for Power Tilt and Power Telescopic Steering Column | - | - |