Installation [09/2022 - ]: Procedure

INSTALL STEERING INTERMEDIATE SHAFT ASSEMBLY

Align the matchmarks on the steering intermediate shaft assembly and steering column assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Matchmark
	Install in this direction

Install the steering intermediate shaft assembly to the steering column assembly.
Install the bolt.
Torque: 35 N.m (357 kgf/cm, 26 ft.lbf)

Tighten the clamp.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL STEERING COLUMN HOLE COVER
1. Install the steering column hole cover with the 2 clips.
2. Install the clip.
3. Return the floor carpet.
CONNECT STEERING INTERMEDIATE SHAFT ASSEMBLY
Refer to PROCEDURE - Step 13
INSTALL FRONT WHEEL LH
Refer to PROCEDURE - Step 1

INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY

Engage the 3 claws to install a new No. 1 air duct sub-assembly.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to INSTALLATION [08/2020 - ]

INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY

NOTE:

Do not remove/install the spiral cable with sensor sub-assembly with the auxiliary battery connected and the engine switch (for Gasoline Model) or power switch (for HV Model) on (IG).
Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the auxiliary battery connected and the engine switch (for Gasoline Model) or power switch (for HV Model) on (IG).
Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Using pliers, expand the clamp.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Clamp

While holding the clamp expanded, install the turn signal switch assembly with spiral cable sub-assembly to the steering column assembly and engage the claw.
Return the clamp to its original position.
Connect the connectors to the turn signal switch assembly with spiral cable sub-assembly.

INSTALL UPPER STEERING COLUMN COVER

Engage the 2 claws and 4 clips to connect the upper steering column cover.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Engage the claw to install the upper steering column cover.

Install in this direction

INSTALL LOWER STEERING COLUMN COVER SUB-ASSEMBLY

Engage the 2 claws to install the lower steering column cover sub-assembly.

Install the 3 screws.

ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 9
INSTALL STEERING WHEEL ASSEMBLY
See step 8
CHECK STEERING WHEEL CENTER POINT
INSTALL HORN BUTTON ASSEMBLY
Refer to INSTALLATION [08/2020 - ]
CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
1. Set the auto tilt away function setting to the previous condition by changing the customize parameter.
  for Gasoline Model: Refer to CUSTOMIZE PARAMETERS [06/2018 - ]
  
  for HV Model: Refer to CUSTOMIZE PARAMETERS [06/2018 - ]
PERFORM INITIALIZATION AND CALIBRATION (for Gasoline Model)
for Parking Support Brake System Calibration: Refer to CALIBRATION [09/2022 - ]
PERFORM INITIALIZATION AND CALIBRATION (for HV Model)
for Parking Support Brake System Calibration: Refer to CALIBRATION [09/2022 - ]
PERFORM REGISTRATION (for Gasoline Model)
Refer to REGISTRATION [09/2022 - ]
PERFORM REGISTRATION (for HV Model)
Refer to REGISTRATION [09/2022 - ]