LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> ES 350 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Engine Mechanical System (A25A-FXS) - Service Information (1 Of 3)) >> Rear Crankshaft Oil Seal >> Removal [09/2022 - ] >> Procedure

Removal [09/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2024 Lexus ES 300h, 2023 Lexus ES 300h, 2022 Lexus ES 300h, 2021 Lexus ES 300h, and 2020 Lexus ES 300h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [09/2022 - ]

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY 
    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.
      NOTE:
      • Using height adjustment attachments and plate lift attachments, keep the engine assembly horizontal.
      • To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments under the No. 2 oil pan sub-assembly of the engine assembly.
      • Using an engine sling device and engine lift, secure the engine assembly before servicing.
    2. Using SST, hold the crankshaft pulley assembly.
      • SST: 09213-54015 
      • SST: 09330-00021 
      GTY757379Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 6 bolts and transmission input damper assembly from the flywheel sub-assembly.
      GTY773086Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE FLYWHEEL SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft pulley assembly.
      • SST: 09213-54015 
      • SST: 09330-00021 
      GTY757380Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 8 bolts and flywheel sub-assembly from the crankshaft.
      GTY761220Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE NO. 1 CRANKSHAFT POSITION SENSOR PLATE 
    1. Type A:
      1. Remove the No. 1 crankshaft position sensor plate.
        GTY761088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Type B:
      1. Remove the No. 1 crankshaft position sensor plate.
        GTY947951Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE REAR ENGINE OIL SEAL 
    1. Using a knife, cut off the lip of the rear engine oil seal.
      GTY752885Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Cut Position
    2. Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
      NOTE:

      Be careful not to damage the crankshaft.

scientia non olet · About LEMON Manuals