Adjustment [10/2022 - ]: Procedure

INSPECT REAR DOOR

Check that the clearance measurements of areas a through n are within each standard range.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

STANDARD CLEARANCE

Area	Measurement	Area	Measurement
a	3.2 to 7.2 mm (0.126 to 0.283 in.)	b	-2.0 to 2.0 mm (-0.0787 to 0.0787 in.)
c	2.5 to 4.9 mm (0.098 to 0.193 in.)	d	-1.2 to 1.2 mm (-0.047 to 0.047 in.)
e	3.6 to 5.6 mm (0.142 to 0.220 in.)	f	-2.0 to 2.0 mm (-0.0787 to 0.0787 in.)
g	3.1 to 7.1 mm (0.122 to 0.280 in.)	h	-0.20 to 3.8 mm (-0.008 to 0.150 in.)
i	3.7 to 7.7 mm (0.146 to 0.303 in.)	j	-1.5 to 2.5 mm (-0.059 to 0.098 in.)
k	1.7 to 4.7 mm (0.067 to 0.185 in.)	l	-1.5 to 1.5 mm (-0.059 to 0.059 in.)
m	2.5 to 5.5 mm (0.098 to 0.217 in.)	n	-2.0 to 2.0 mm (-0.0787 to 0.0787 in.)

ADJUST REAR DOOR

NOTE:

Make sure to turn the ignition switch off when adjusting door lock strikers.

Using SST, loosen the 4 hinge bolts on the vehicle body and adjust the door position.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Tighten the 4 hinge bolts on the vehicle body after adjustment.
Torque: 26 N.m (265 kgf/cm, 19 ft.lbf)
Loosen the 4 hinge bolts on the door and adjust the door position.
Tighten the 4 hinge bolts on the door after adjustment.
Torque: 26 N.m (265 kgf/cm, 19 ft.lbf)

Disengage the 4 claws to remove the rear door lock striker cover.

Using a T40 "TORX" socket wrench, slightly loosen the 2 striker mounting screws.

Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the 2 striker mounting screws after adjustment.
Torque: 23 N.m (235 kgf/cm, 17 ft.lbf)

Engage the 4 claws to install the rear door lock striker cover.