Caution / Notice / Hint
NOTE:
- Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed.
Refer to PRECAUTION [10/2022 - ]
- When replacing the combination meter assembly, replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in the combination meter assembly will not match the information from the vehicle and a DTC may be stored.
- When replacing the combination meter assembly, make sure to update the ECU security key.
Refer to UPDATE ECU SECURITY KEY [10/2022 - ]
HINT:
- Before disconnecting the connectors for inspection, push each connector in the connection direction and check that it is not loose or disconnected.
- After disconnecting the connector, check that the connector and terminals are not damaged, deformed or corroded.