Removal [10/2022 - ]: Procedure
- REMOVE BACK DOOR UPPER TRIM COVER
Refer to PROCEDURE - Step 1
- REMOVE BACK DOOR SIDE GARNISH LH
Refer to PROCEDURE - Step 2
- REMOVE BACK DOOR SIDE GARNISH RH
- Use the same procedure as for the LH side.
- REMOVE BACK DOOR LOCK COVER
Refer to PROCEDURE - Step 4
- REMOVE BACK DOOR INSIDE HANDLE
Refer to PROCEDURE - Step 5 - REMOVE NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE BACK DOOR TRIM BOARD ASSEMBLY
Refer to PROCEDURE - Step 8
- DISCONNECT POWER BACK DOOR UNIT ASSEMBLY LH
Refer to PROCEDURE - Step 8
- DISCONNECT POWER BACK DOOR UNIT ASSEMBLY RH
- Use the same procedure as for the LH side.
- REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH
Refer to PROCEDURE - Step 9
- REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH
- Use the same procedure as for the LH side.
- REMOVE REAR LIGHT ASSEMBLY
*a Connector *b Grommet *c Nut *d Bolt Protective Tape - - - Apply protective tape around the rear light assembly as shown in the illustration.
- Disconnect the connector.
- Disconnect the grommet.
- Remove the 2 bolts and 6 nuts.
- Using a moulding remover, disengage the 6 clips and guide to remove the rear light assembly.