Installation [10/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL ENGINE OIL LEVEL SENSOR

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using an 8 mm socket wrench, install the engine oil level sensor to the engine balancer assembly with the 2 bolts.
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
Remove any dirt or foreign matter from the engine oil level sensor connector installation hole.
Apply a light coat of engine oil to the O-ring of the engine oil level sensor.
Install a new clip to the engine oil level sensor.
Connect the engine oil level sensor connector.
NOTE:
If there is any engine oil on the connector, clean the connector using a cloth or similar.

INSTALL NO. 2 OIL PAN SUB-ASSEMBLY

for 1Motor-HEV Model:
Refer to PROCEDURE - Step 10
for Gasoline Model:
Refer to PROCEDURE - Step 10

ADD ENGINE OIL
Refer to PROCEDURE - Step 5
INSPECT FOR ENGINE OIL LEAK
Refer to PROCEDURE - Step 6
CHECK ENGINE OIL LEVEL
for 1Motor-HEV Model:

Refer to PROCEDURE - Step 1

for Gasoline Model:

Refer to PROCEDURE - Step 1
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)