Installation [10/2022 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL TIMING CHAIN CASE OIL SEAL
*a 0 to 2 mm - - - Apply MP grease to the lip of a new timing chain case oil seal.NOTE:
- Keep the lip free from foreign matter.
- Do not allow MP grease to contact the dust seal.
- Make sure there is no oil on the outer surface.
- Using SST and a hammer, tap in the timing chain case oil seal.
- SST: 09223-00010
Standard Depth
0 to 2 mm (0 to 0.0787 in.) (From the edge of the No. 2 timing chain cover assembly)
NOTE:Do not tap in the timing chain case oil seal at an angle.
- Apply MP grease to the lip of a new timing chain case oil seal.
- INSTALL CRANKSHAFT PULLEY ASSEMBLY
Refer to PROCEDURE - Step 43 - INSTALL V-RIBBED BELT
Refer to PROCEDURE - Step 1 - INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
Refer to INSTALLATION [10/2022 - ]