Removal [11/2021 - 03/2023]: Procedure
- REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY
Refer to REMOVAL [11/2021 - 03/2023]
- REMOVE REAR STABILIZER BAR
Refer to PROCEDURE - Step 6
- REMOVE REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
*1 Rear Suspension Member Sub-assembly - - *a Turn *b Hold Turning Direction Front of Vehicle SST Bolt Position - - - Using SST, remove the rear No. 1 differential mount cushion.
- SST: 09316-12010
- SST: 09570-24011
NOTE:- Before using SST, apply grease to the SST bolts.
- Be sure to use the correct combination of SST.
- Be sure to use the correct direction of SST.
- Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
- Do not tilt the bolts of SST.
- Using SST, remove the rear No. 1 differential mount cushion.