LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> NX 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Electronically Controlled Brake System - Diagnostic Codes (5 Of 6)) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HEV Model) >> DTC C141C-49: Brake Booster Motor "A" Control Internal Electronic Failure [11/2021 - ] >> Component Operating Range

Component Operating Range

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
C141C (CASE 1)

All of the following conditions are met -
Brake system voltage 1 Higher than 7.3 V and less than 23.2 V
Output duty order value (command to motor relay port) 100%
Motor circuit current Less than 264.00 A
C141C (CASE 2 TO 9)

Both of the following conditions are met A and B
A. All of the following conditions are met at the ECU status (last IG ON timing final) -
Brake system voltage fail (C12FA, C12FB) Not detected
Brake booster motor fail (C141C, C141D, C141E, C141F) Not detected
Brake pressure control solenoid fail (C14F4, C14FD, C150A, C1510) Not detected
B. All of the following conditions are met at the ECU status (pre main) -
Brake system voltage fail (C121F, C12FA, C12FB) Not detected
Brake booster motor fail (C141C) Not detected
Brake pressure control solenoid fail (C14F3, C14F4, C14FC, C14FD, C1509, C150A, C150F, C1510) Not detected
C141C (CASE 10)

All of the following conditions are met A, B, C, D, E, F, G, H, I and J
A. Brake system voltage 1 Less than 23.2 V
B. MRI1 voltage 5.7 V or more
C. Motor relay input signal permission On
D. Command to motor relay On
E. Motor duty output order value 100%
F. Command to reverse battery protection MOS Off
G. Command to motor fail-safe relay Off
H. ASIC output permission Off
I. All of the following conditions are met at the ECU status (last IG ON timing final) -
Brake system voltage fail (C12FA, C12FB) Not detected
Brake booster motor fail (C141C, C141D, C141E, C141F) Not detected
Brake pressure control solenoid fail (C14F4, C14FD, C150A, C1510) Not detected
J. All of the following conditions are met at the ECU status (pre main) -
Brake system voltage fail (C121F, C12FA, C12FB) Not detected
Brake booster motor fail (C141C) Not detected
Brake pressure control solenoid fail (C14F3, C14F4, C14FC, C14FD, C1509, C150A, C150F, C1510) Not detected