LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> NX 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Electronically Controlled Brake System - Diagnostic Codes (6 Of 6), Symptom Tests & Circuit Tests) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HEV Model) >> DTC P2530-14: Ignition Switch Run Position Circuit Short to Ground or Open [11/2021 - ] >> Description

DTC P2530-14: Ignition Switch Run Position Circuit Short to Ground or Open [11/2021 - ]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.

If a malfunction is detected in the power supply circuit, the No. 2 skid control ECU (brake actuator assembly) power source voltage drops, or there is insufficient voltage to operate the main relay, the No. 2 skid control ECU (brake actuator assembly) will store these DTCs.

If the auxiliary battery voltage is temporarily low, this DTC may be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL DTC Output from Note
P2530-14 Ignition Switch Run Position Circuit Short to Ground or Open When communication with the hybrid vehicle control ECU is normal or the vehicle speed is 10 km/h (6 mph) or more, and the IG1 terminal voltage is 9.5 V or more, the IG2 terminal voltage is less than 3 V for 4 seconds or more.
  • Open or short in IG2 circuit
  • Improperly connected connector, deformation or corrosion of terminals
  • No. 2 skid control ECU (brake actuator assembly)
Comes on Brake/EPB
  • SAE Code: P2531 (Case 2)
  • Output ECU: No. 2 skid control ECU (brake actuator assembly)