DTC P0335-1F: Crankshaft Position Sensor "A" Circuit Intermittent; DTC P0335-2A: Crankshaft Position Sensor "A" Signal Stuck in Range; DTC P0335-31: Crankshaft Position Sensor "A" No Signal [11/2021 - ]: Description

WARNING: This page is about a different car, the 2025 Lexus NX 350, 2024 Lexus NX 350, 2023 Lexus NX 350, and 2022 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.

Refer to DTC P0335-11.

Refer to DESCRIPTION

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Note
P0335-1F	Crankshaft Position Sensor "A" Circuit Intermittent	Under conditions (a), (b) and (c), no crankshaft position sensor signal to ECM for 0.05 seconds or more (1 trip detection logic): (a) Engine speed is 1000 rpm or higher. (b) Starter signal is off. (c) 3 seconds or more have elapsed since the starter signal switched from on to off. *	Open or short in crankshaft position sensor circuit Crankshaft position sensor No. 1 crankshaft position sensor plate ECM	Does not come on	SAE Code: P0339
P0335-2A	Crankshaft Position Sensor "A" Signal Stuck in Range	No crankshaft position sensor signal to the ECM while cranking (1 trip detection logic). *	Open or short in crankshaft position sensor circuit Crankshaft position sensor No. 1 crankshaft position sensor plate ECM	Comes on	SAE Code: P0335
P0335-31	Crankshaft Position Sensor "A" No Signal	The engine stalls and the engine speed signal value decreases rapidly (1 trip detection logic). *	Open or short in crankshaft position sensor circuit Crankshaft position sensor No. 1 crankshaft position sensor plate ECM	Comes on	SAE Code: P0335

*: When the engine is being stopped or started automatically by stop and start system control, the ECM does not monitor the crankshaft position sensor signal.

Reference: Inspection using an oscilloscope.
Refer to DESCRIPTION