LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> NX 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Engine Control System - Diagnostic Codes (P0441-P050B)) >> SFI System >> DTC P0466-73: EVAP System Vent Valve Stuck Closed Actuator Stuck Closed [03/2022 - ] >> DTC Summary

DTC Summary

WARNING: This page is about a different car, the 2025 Lexus NX 350h, 2024 Lexus NX 350h, 2023 Lexus NX 350h, and 2022 Lexus NX 350h. However, it is still accessible from the selected car via links, so may be relevant.
DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note
P0466-73 EVAP System Vent Valve Stuck Closed Actuator Stuck Closed Following condition is met during key-off EVAP monitor:
  • EVAP pressure change when vent valve on (closed) less than 0.3 kPa [0.04 psi]
  • Canister pump module (reference orifice, leak detection pump, vent valve)
  • Connector/wire harness (Canister pump module - ECM)
  • Canister (filter inside canister clogged)
  • ECM
Comes on
  • SAE Code: P2422
  • DTC for Mexico Models: Applies
DTC No. Monitoring Item Detection Timing Detection Logic SAE Code
P0466-73 Vent valve (built into canister pump module) stuck closed EVAP monitoring
(ignition switch off)
2 trip P2422

HINT: 

The vent valve is built into the canister pump module.