Installation [12/2021 - ]: Procedure
- INSTALL SPARK PLUG NOTE:
If a spark plug has been struck or dropped, replace it.
Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)
- INSTALL IGNITION COIL ASSEMBLY
Refer to PROCEDURE - Step 2 - INSTALL BRACKET
Refer to PROCEDURE - Step 3
- CONNECT PURGE VSV (DUTY VACUUM SWITCHING VALVE)
- CONNECT NO. 1 VENTILATION PRESSURE SENSOR HOSE
- CONNECT NO. 4 WATER BY-PASS PIPE
Refer to PROCEDURE - Step 6
- CONNECT ENGINE WIRE
Refer to PROCEDURE - Step 7
- INSTALL V-BANK COVER SUB-ASSEMBLY
- PERFORM INITIALIZATION
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
- w/ Canister Pump Module:
Refer to INITIALIZATION [12/2021 - ]
- w/o Canister Pump Module:
Refer to INITIALIZATION [12/2021 - ]
- w/ Canister Pump Module:
- Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.