Odo/Trip Switch Malfunction [12/2021 - ]: Procedure

1. Using the GTS, read the Data List.

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   ODO/TRIP Change Switch	ODO/TRIP switch (Trip switch)	OFF or ON	OFF: ODO/TRIP switch (trip switch) released ON: ODO/TRIP switch (trip switch) pushed	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   ODO/TRIP Change Switch

   OK

   ODO/TRIP switch condition displayed on the GTS changes with the actual switch operation.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

See step  2

Refer to INSPECTION [12/2021 - ]

Result

Result: 

NG 

REPLACE TRIP SWITCH. Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  3

1. Disconnect the I5 combination meter assembly connector.
2. Disconnect the I80 trip switch connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I5-20 (ODO) - I80-4 (+)	Always	Below 1 Ω
   I5-19 (SW3) - I80-7 (E)	Always	Below 1 Ω
   I5-20 (ODO) or I80-4 (+) - Body ground	Always	10 kΩ or higher
   I5-19 (SW3) or I80-7 (E) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR