Entire Combination Meter does not Operate [12/2021 - ]: Procedure

1. Disconnect the I5 combination meter assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I5-1 (EP) - Body ground	Always	Below 1 Ω
   I5-2 (ET) - Body ground	Always	Below 1 Ω

3. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   I5-6 (IG+) - Body ground	Ignition switch off	Below 1 V
   	Ignition switch ON	11 to 14 V*1 10.5 to 16 V*2
   I5-5 (B) - Body ground	Always	11 to 14 V

   1. *1: w/o Stop and Start System

      *2: w/ Stop and Start System

   Result

   Result	Proceed to
   OK	A
   NG (IG+ terminal) (w/ Stop and Start System)	B
   NG (IG+ terminal) (w/o Stop and Start System)	C
   NG (Other terminal)

Result: 

A 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

B 

GO TO STOP AND START SYSTEM. Refer to  Backup Boost Converter Circuit [12/2021 - 10/2023]  , or refer to  Backup Boost Converter Circuit [10/2023 - ] 

Result: 

C 

REPAIR OR REPLACE HARNESS OR CONNECTOR