Engine Oil Level Sensor Circuit [12/2021 - ]: Procedure

Refer to INSPECTION [12/2021 - ]

Result

Result: 

NG 

REPLACE ENGINE OIL LEVEL SENSOR. Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  2

1. Disconnect the I6 combination meter assembly connector.
2. Disconnect the C26 engine oil level sensor connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I6-10 (OILW) - C26-1 (LOIL)	Always	Below 1 Ω
   I6-10 (OILW) or C26-1 (LOIL) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR