DTC B1501-13: Sub Fuel Sender Circuit Open [12/2021 - ]: Procedure

Refer to INSPECTION [12/2021 - ]

Result

Result: 

NG 

REPLACE NO. 2 FUEL SENDER GAUGE ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  2

Pre-procedure1

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the fuel tank vent tube assembly.

   Refer to REMOVAL [12/2021 - ]

   Procedure1

2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   A-1 (FV2) - B-1	Always	Below 1 Ω
   A-2 (FE2) - B-2	Always	Below 1 Ω
   A-3 (FR2) - B-3	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

   Post-procedure1

3. None

Result: 

NG 

REPLACE FUEL TANK VENT TUBE ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

OK 

See step  3

Pre-procedure1

1. Disconnect the V10 No. 2 fuel tank vent tube assembly connector.
2. Disconnect the I5 combination meter assembly connector.

   Procedure1

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   V10-3 (FR2) - I5-8 (FR)	Always	Below 1 Ω
   V10-2 (FE2) - I5-34 (FE)	Always	Below 1 Ω
   V10-1 (FV2) - I5-24 (FV)	Always	Below 1 Ω
   I5-8 (FR) - Body ground	Always	10 kΩ or higher
   I5-34 (FE) - Body ground	Always	10 kΩ or higher
   I5-24 (FV) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

   Post-procedure1

4. None

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [12/2021 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR