DTC B0055-11: Second Row Right Seat Belt Sensor Circuit Short to Ground [11/2021 - 10/2023]: Procedure

CHECK CONNECTION OF CONNECTORS

Pre-procedure1

Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 60 seconds.
Procedure1

Check that the connectors are properly connected to the airbag ECU assembly and rear seat inner belt assembly RH.

The connectors are properly connected.

Result

Proceed to
OK
NG

Post-procedure1

None

Result:

CONNECT CONNECTORS PROPERLY

Result:

See step 2

CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN THE CIRCUIT)

Pre-procedure1

Disconnect the airbag ECU assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Rear Seat Inner Belt Assembly RH
*2	Airbag ECU Assembly
*3	Wire Harness
*a	Front view of wire harness connector (to Rear Seat Inner Belt Assembly RH)
*b	Front view of wire harness connector (to Airbag ECU Assembly)

Disconnect the rear seat inner belt assembly RH assembly connector.
Procedure1

Measure the resistance according to the value(s) in the table below.

Standard Resistance

Tester Connection	Condition	Specified Condition
R15-1 - R15-2	Always	1 MΩ or higher

Result

Proceed to
OK
NG

Post-procedure1

None

Result:

REPAIR OR REPLACE HARNESS OR CONNECTOR

Result:

See step 3

CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT TO GROUND IN THE CIRCUIT)

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Rear Seat Inner Belt Assembly RH
*2	Airbag ECU Assembly
*3	Wire Harness
*a	Front view of wire harness connector (to Rear Seat Inner Belt Assembly RH)
*b	Front view of wire harness connector (to Airbag ECU Assembly)

Standard Resistance

Tester Connection	Condition	Specified Condition
R15-1 - Body ground	Always	1 MΩ or higher
R15-2 - Body ground	Always	1 MΩ or higher

Result

Proceed to
OK
NG

Result:

REPAIR OR REPLACE HARNESS OR CONNECTOR

Result:

See step 4

CLEAR DTC

Connect the airbag ECU assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Rear Seat Inner Belt Assembly RH
*2	Airbag ECU Assembly
*3	Wire Harness

Connect the rear seat inner belt assembly RH connector.
Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
Turn the power switch on (IG), and wait for at least 60 seconds.

Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs

Result

Proceed to
NEXT

Result:

See step 5

CHECK DTC

Pre-procedure1

Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Procedure1

Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes

Result

Result	Proceed to
B0055-11 is not output	A
B0055-11 is output	B

Post-procedure1

None

Result:

USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2021 - 10/2022] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2022 - 10/2023]

Result:

REPLACE AIRBAG ECU ASSEMBLY. Refer to REMOVAL [11/2021 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023]