LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LS 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Hybrid Transaxle System (L310) - Service Information (2 Of 2)) >> Shift Control Ecu >> Removal [10/2017 - 09/2018] >> Procedure

Removal [10/2017 - 09/2018]: Procedure

WARNING: This page is about a different car, the 2022 Lexus LS 500h, 2021 Lexus LS 500h, 2020 Lexus LS 500h, 2019 Lexus LS 500h, and 2018 Lexus LS 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  2. REMOVE TOOL BOX 

    Refer to PROCEDURE - Step 2

  3. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    Refer to PRECAUTION [10/2017 - 10/2020]

    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [10/2017 - 09/2019]

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    It is necessary to remove the shift control ECU while no power is being supplied from the sub-battery. Therefore, perform the following procedures.

    1. Turn the power switch off.
    2. Check that the ODO meter display has turned off.

      HINT: 

      The ODO meter continues to display for 30 seconds after turning off. Therefore, allow sufficient time for the shift control ECU to enter sleep mode and for the sub-battery power supply to end. In addition to monitoring the sub-battery voltage directly, the only other method for checking on the vehicle is to use the ODO meter display.

    3. Check that the voltage between the terminals of the sub-battery assembly with control is 0 V.

      Refer to REMOVAL [10/2017 - 09/2018]

      GTY816277Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Disconnect the cable from the negative (-) auxiliary battery terminal.
      NOTE:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [10/2017 - 09/2018]

  5. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY 

    Refer to PROCEDURE - Step 30

  6. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 57

  7. REMOVE SHIFT CONTROL ECU 
    1. Disconnect the 3 shift control ECU connectors.
      GTY799322Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and shift control ECU.
      GTY799320Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NO. 1 SHIFT CONTROL ECU BRACKET 
    1. Remove the bolt and No. 1 shift control ECU bracket from the shift control ECU.
      GTY832557Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE NO. 2 SHIFT CONTROL ECU BRACKET 
    1. Remove the bolt and No. 2 shift control ECU bracket from the shift control ECU.
      GTY799321Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals