Installation [10/2017 - ]: Procedure
- INSTALL REAR NO. 1 DIFFERENTIAL MOUNT CUSHION
- Using SST, install a new rear No. 1 differential mount cushion.
- SST: 09570-24011
- SST: 09570-48010
*a SST (09570-48010) *b SST (09570-24011) *c 0° +/- 3° - - SST bolt location Front of the Vehicle NOTE:- Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.
- Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.
- Before using SST, apply grease to the SST bolts.
- Be sure to use the correct combination of SST.
- Do not tilt the bolts of SST.
- Tighten the 2 bolts of SST so that they enter the 2 holes of the rear No. 1 differential mount cushion by an equal amount.
HINT:
Install the 2 SST bolts to the 2 SST holes as shown in the illustration.
- Using SST, install a new rear No. 1 differential mount cushion.
- INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY