DTC C1345-00: Linear Solenoid Valve Offset Learning [11/2021 - 10/2023]: Procedure

1. Check that no DTCs other than those related to incomplete learning are output.

   Chassis > Brake Booster > Trouble Codes 

   Chassis > Brake/EPB > Trouble Codes 

   OK

   DTCs other than those related to incomplete learning are not output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR CIRCUITS INDICATED BY OUTPUT DTCS 

Result: 

OK 

See step  2

1. Perform the air bleeding procedure in Bleed Brake System.

   Refer to BLEEDING [11/2021 - 10/2023]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Check and ensure the following conditions required for performing linear solenoid valve offset learning and then perform linear solenoid valve offset learning.

   Refer to UTILITY [11/2021 - 10/2023]

   NOTE:

   If DTC C1345-54 is output, turn the ignition switch off for 3 minutes or more and then turn the ignition switch to ON again before performing learning.

   Chassis > Brake/EPB > Utility 

   Tester Display
   Calibration

   1. The auxiliary battery voltage is 11 to 15.5 V when the ignition switch is ON (READY).
   2. The brake booster with master cylinder assembly is not hot.
   3. The hybrid control system is not malfunctioning.
   4. The shift state indicator shows that the shift lever is in P.
   5. The READY light in the combination meter assembly is illuminated.
   6. The brake pedal is not depressed.
   7. The parking brake is released.
   8. DTCs C1451-00 or C1451-51 is not output. (If it is output, bleed the air from the high-pressure tube.)

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Clear the DTCs.

   Chassis > Brake/EPB > Clear DTCs 

2. Turn the ignition switch off.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  5

1. Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.
2. Check if the same DTC is output.

   Chassis > Brake/EPB > Trouble Codes 

   Result

   Result	Proceed to
   DTC C1345-00 is not output.	A
   DTC C1345-00 is output.	B

Result: 

A 

END 

Result: 

B 

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY. Refer to  REMOVAL [11/2021 - 10/2022]  , or refer to  REMOVAL [10/2022 - 10/2023]