LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LS 500h >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Electronically Controlled Brake System (W/ Advanced Park) - Diagnostic Codes (4 Of 5) >> ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/ Advanced Park) >> DTC C12F8-12: ECB Solenoid Control "A" Circuit Short to Battery; DTC C12F8-14: ECB Solenoid Control "A" Circuit Short to Ground or Open [11/2021 - 10/2023] >> Component Operating Range

Component Operating Range

C12FA (CASE 1 AND 2) AND C12FB (CASE 1)

Both of the following conditions are met A and B
A. All of the following conditions are met at the ECU status (last IG ON timing final) -
Brake system voltage fail (C12FA, C12FB) Not detected
Brake booster motor fail (C141C, C141D, C141E, C141F) Not detected
Brake pressure control solenoid fail (C14F4, C14FD, C150A, C1510) Not detected
B. All of the following conditions are met at the ECU status (pre main) -
Brake system voltage fail (C121F, C12FA, C12FB) Not detected
Brake booster motor fail (C141C) Not detected
Brake pressure control solenoid fail (C14F3, C14F4, C14FC, C14FD, C1509, C150A, C150F, C1510) Not detected
C12FA (CASE 3)

All of the following conditions are met A, B, C and D
A. Solenoid relay On
B. Brake system voltage 1 Higher than 7.3 V
C. All of the following conditions are met at the ECU status (last IG ON timing final) -
Brake system voltage fail (C12FA, C12FB) Not detected
Brake booster motor fail (C141C, C141D, C141E, C141F) Not detected
Brake pressure control solenoid fail (C14F4, C14FD, C150A, C1510) Not detected
D. All of the following conditions are met at the ECU status (pre main) -
Brake system voltage fail (C121F, C12FA, C12FB) Not detected
Brake booster motor fail (C141C) Not detected
Brake pressure control solenoid fail (C14F3, C14F4, C14FC, C14FD, C1509, C150A, C150F, C1510) Not detected
C12FB (CASE 2)

All of the following conditions are met A, B and C
A. Solenoid relay Off
B. All of the following conditions are met at the ECU status (last IG ON timing final) -
Brake system voltage fail (C12FA, C12FB) Not detected
Brake booster motor fail (C141C, C141D, C141E, C141F) Not detected
Brake pressure control solenoid fail (C14F4, C14FD, C150A, C1510) Not detected
C. All of the following conditions are met at the ECU status (pre main) -
Brake system voltage fail (C121F, C12FA, C12FB) Not detected
Brake booster motor fail (C141C) Not detected
Brake pressure control solenoid fail (C14F3, C14F4, C14FC, C14FD, C1509, C150A, C150F, C1510) Not detected