Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the kick door control sensor removal/installation are shown below.
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function When Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Removal and installation of auxiliary battery terminal | Memorize steering angle neutral point | Lane-keeping assist system (for Mono camera type) | for Stereo Camera type: Refer to INITIALIZATION [10/2017 - 10/2020] for Mono Camera type: Refer to INITIALIZATION [10/2017 - 09/2018] |
| Lane control system (for Stereo camera type) | |||
| Parking support brake system* | |||
| Pre-collision system (for Mono camera type) | |||
| Pre-collision system (for Stereo camera type) | |||
| AFS (Front-lighting adaptive system) | |||
Lighting system (EXT)
|
|||
| Variable gear ratio steering system | Refer to INITIALIZATION [10/2017 - 10/2020] | ||
| Parking assist monitor system | Refer to INITIALIZATION [10/2017 - 10/2020] | ||
| Panoramic view monitor system | Refer to INITIALIZATION [10/2017 - 10/2022] | ||
| Initialize Rear Door Sunshade System | Rear door sunshade system | Refer to INITIALIZATION [10/2017 - ] | |
| Initialize power trunk lid system | Power trunk lid system | Refer to INITIALIZATION [10/2017 - 10/2020] | |
| Kick door control sensor | Reset connection history | There are cases where the connection history display differs from the vehicle condition | Refer to DATA LIST / ACTIVE TEST [10/2017 - 10/2023] |
*: When performing learning using the Techstream.