Hazard Warning Switch Circuit [10/2017 - 10/2020]: Procedure

1. Using the Techstream, read the Data List.

   Refer to DATA LIST / ACTIVE TEST [10/2017 - 09/2018] , or refer to DATA LIST / ACTIVE TEST [09/2018 - 10/2020]

   Body Electrical > Combination Meter > Data List 

   Tester Display	Measurement Item	Normal Condition	Reference Value	Diagnostic Note
   Hazard Flasher Switch	Hazard warning signal switch assembly	OFF or ON	OFF: Hazard warning signal switch assembly off ON: Hazard warning signal switch assembly on	-

   Body Electrical > Combination Meter > Data List 

   Tester Display
   Hazard Flasher Switch

   OK

   Normal condition listed above is displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [10/2017 - 09/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [09/2018 - 10/2020] 

Result: 

NG 

See step  2

1. Remove the hazard warning signal switch assembly.

   Refer to REMOVAL [10/2017 - ]

2. Inspect the hazard warning signal switch assembly.

   Refer to INSPECTION [10/2017 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE HAZARD WARNING SIGNAL SWITCH ASSEMBLY. Refer to  REMOVAL [10/2017 - ] 

Result: 

OK 

See step  3

1. Disconnect the AA hazard warning signal switch assembly connector.
2. Disconnect the G34 combination meter assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   AA-6 (HAZ) - G34-2 (HZSW)	Always	Below 1 Ω
   AA-3 (E) - Body ground	Always	Below 1 Ω
   AA-6 (HAZ) or G34-2 (HZSW) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE COMBINATION METER ASSEMBLY. Refer to  REMOVAL [10/2017 - 10/2020] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR