Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the windshield glass removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedures	Necessary Procedures	Effect/Inoperative Function when Necessary Procedures are not Performed	Link
for Stereo Camera Type: Windshield glass (Including removal and installation)	Adjust object recognition camera	Dynamic radar cruise control system (for Stereo camera type) Front camera system (for Stereo camera type) Lane tracing assist system (for Stereo camera type) Road sign assist system (for Stereo camera type) Pre-collision system (for Stereo camera type) Automatic high beam system	One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [10/2020 - 10/2023] Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [10/2020 - 10/2023]
for Mono Camera Type: Windshield glass (Including removal and installation)	Adjust forward recognition camera	Dynamic radar cruise control system (for Mono camera type) Front camera system (for Mono camera type) Lane tracing assist system (for Mono camera type) Road sign assist system (for Mono camera type) Pre-collision system (for Mono camera type) Automatic high beam system	One Time Recognition: Refer to ADJUSTMENT (ONE TIME RECOGNITION) [10/2020 - 11/2021] Sequential Recognition: Refer to ADJUSTMENT (SEQUENTIAL RECOGNITION) [10/2020 - 11/2021]

HINT:

Use the same procedure for the RH and LH side.
The following procedure is for the LH side.