Components [12/2017 - ]
| *1 | LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY | *2 | NEGATIVE BATTERY TERMINAL |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | - | - |
| *A | w/o Rear Door Sunshade | *B | w/ Rear Door Sunshade |
| *1 | REAR DOOR ARMREST COVER LH | *2 | REAR DOOR NO. 2 ARMREST COVER LH |
| *3 | REAR DOOR TRIM BOARD SUB-ASSEMBLY LH | *4 | REAR DOOR TRIM UPPER COVER LH |
| *A | w/o Rear Door Sunshade | *B | w/ Rear Door Sunshade |
| *1 | CURTAIN RAIL SIDE COVER LH | *2 | REAR CURTAIN SUB-ASSEMBLY LH |
| *3 | REAR DOOR FRAME GARNISH LH | *4 | REAR DOOR GLASS INNER WEATHERSTRIP LH |
| *5 | REAR DOOR NO. 2 FRAME GARNISH LH | *6 | REAR DOOR TRIM COVER LH |
| *7 | REAR SIDE WINDOW COVER LH | - | - |
| *1 | REAR DOOR FRONT BELT MOULDING END COVER LH | *2 | REAR DOOR NO. 2 WEATHERSTRIP LH |
| *3 | REAR DOOR REAR BELT MOULDING END COVER LH | *4 | REAR DOOR SERVICE HOLE COVER LH |
| *5 | REAR MULTIPLEX NETWORK DOOR ECU LH | - | - |
| • | Non-reusable part | - | - |
| *1 | REAR DOOR BELT MOULDING SUB-ASSEMBLY LH | *2 | REAR DOOR FRONT GLASS RUN LH |
| *3 | REAR DOOR NO. 3 GLASS RUN LH | *4 | REAR DOOR OUTSIDE MOULDING INSERT LH |
| *5 | REAR DOOR UPPER WINDOW FRAME MOULDING LH | *6 | REAR DOOR WINDOW FRAME MOULDING LH (CENTER PILLAR SIDE) |
| *7 | REAR DOOR WINDOW FRAME MOULDING LH (REAR PILLAR SIDE) | *8 | RIVET |
| N.m (kgf/cm, ft.lbf): Specified torque | • | Non-reusable part |
| *1 | REAR DOOR FRONT WINDOW GUIDE SUB-ASSEMBLY LH | *2 | REAR DOOR GLASS RUN LH |
| *3 | REAR DOOR GLASS SUB-ASSEMBLY LH | *4 | REAR DOOR QUARTER WINDOW GLASS SUB-ASSEMBLY LH |
| *5 | REAR DOOR REAR WINDOW FRAME LH | *6 | PLUG HOLE |
| *7 | RIVET | - | - |
| N.m (kgf/cm, ft.lbf): Specified torque | • | Non-reusable part |