Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the front bumper assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replaced Part or Performed Procedures | Necessary Procedures | Effect/Inoperative Function when Necessary Procedures are not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) battery terminal | Operate the multiplex network master switch assembly (retractable outer mirror switch) to extend and retract the outer rear view mirror assembly | Parking support brake system | Refer to INITIALIZATION [10/2023 - ] |
| Initialize rear door sunshade system | Rear door sunshade system | Refer to INITIALIZATION [12/2017 - ] | |
| Front bumper assembly (Including removal and installation) | Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [10/2023 - ] |
|
Front television camera view adjustment | Panoramic view monitor system | Refer to CALIBRATION [10/2023 - ] |
HINT:
- When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
- Learning completes when vehicle is driven
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. Refer to INITIALIZATION [10/2023 - ] Front camera system AFS (Front-lighting adaptive system) - Learning completes when vehicle is operated normally
Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link Power trunk lid system Fully close the luggage compartment door by hand.
HINT:
Initialization is not necessary if the above procedures are performed while the luggage compartment door is closed.Refer to INITIALIZATION [10/2023 - ]
- Learning completes when vehicle is driven
- When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.
- DRIVING ADJUSTMENT:
Refer to DRIVING ADJUSTMENT [10/2023 - ]
- TARGET ADJUSTMENT (TRIANGLE TARGET):
- TARGET ADJUSTMENT (FLAT SURFACE TARGET):
Refer to TARGET ADJUSTMENT (FLAT SURFACE TARGET) [10/2023 - ]
- DRIVING ADJUSTMENT:
- If the bumper is damaged, there is a possibility that the installation area of the front side radar sensor may be deformed and the front side radar sensor system may not operate correctly, so visually inspect the front side radar sensor installation area (headlight, frame, bracket, stud bolt) to make sure it is not dented or bent.
- If the visual inspection finds a problem, check the installation condition of the front side radar sensor, and adjust the installation position of the front side radar sensor as necessary.
- DRIVING ADJUSTMENT:
Refer to DRIVING ADJUSTMENT [10/2023 - ]
- TARGET ADJUSTMENT (TRIANGLE TARGET):
- DRIVING ADJUSTMENT:
- When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform ultrasonic sensor detection angle measurement.
Refer to CALIBRATION [10/2023 - ]