LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 94 (Brake Control System - Service Information (Coupe)) >> Yaw Rate And Acceleration Sensor >> Removal [04/2020 - ] >> Procedure

Removal [04/2020 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [03/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]

  2. REMOVE NO. 1 CONSOLE BOX SUPPORT 
    1. Detach the clamp and disconnect the indoor electrical key antenna assembly.
      GTY793190Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Indoor Electrical Key Antenna Assembly
    2. Detach the 2 clamps and disconnect the wire harness from the No. 1 console box support.
    3. Remove the 2 clips and disconnect the floor carpet from the No. 1 console box support.
    4. Remove the 3 bolts and No. 1 console box support.
      GTY790453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE NO. 1 CONSOLE BOX MOUNTING BRACKET 
    1. Remove the 4 bolts and No. 1 console box mounting bracket.
      GTY820593Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE YAWRATE SENSOR 
    1. Disconnect the connector from the yaw rate sensor.
      GTY815957Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Identification Number
    2. Remove the 2 nuts and yaw rate sensor assembly.
      NOTE:
      • Make sure the yaw rate sensor's identification number is 9.
      • Do not drop the yaw rate sensor. If it is dropped, do not use it.
scientia non olet · About LEMON Manuals