Installation [03/2017 - 04/2020]: Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL YAW RATE SENSOR ASSEMBLY
- Install the yaw rate sensor with the 2 nuts.
Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
NOTE:- Make sure the yaw rate sensor's identification number is 9.
- If the yaw rate sensor is dropped, replace it with a new one.
- Do not mistake the installation direction of the yaw rate sensor.
- When installing the yaw rate sensor, make sure to avoid impact to the sensor.
- After the installation, check that the yaw rate sensor is not tilted due to the floor carpet or any foreign matter.
*a Identification Number - Connect the connector to the yaw rate sensor.NOTE:
Make sure that the yaw rate sensor connector is connected securely.
- Install the yaw rate sensor with the 2 nuts.
- INSTALL NO. 1 CONSOLE BOX MOUNTING BRACKET
- INSTALL NO. 1 CONSOLE BOX SUPPORT
- Install the No. 1 console box support with the 3 bolts.
Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf)
- Attach the 2 clips and connect the floor carpet to the No. 1 console box support.
*1 Indoor Electrical Key Antenna Assembly - Attach the 2 clamps and connect the wire harness to the No. 1 console box support.
- Attach the clamp and connect the indoor electrical key antenna assembly.
- Install the No. 1 console box support with the 3 bolts.
- INSTALL CONSOLE BOX ASSEMBLY
Refer to INSTALLATION [03/2017 - 05/2023]
- PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE
Refer to INITIALIZATION [03/2017 - ]
- PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
Refer to CALIBRATION [03/2017 - 05/2023]
- CHECK AND CLEAR DTC
Refer to DTC CHECK / CLEAR [03/2017 - 09/2018] , or refer to DTC CHECK / CLEAR [09/2018 - ]