Removal [05/2023 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

PRECAUTION
NOTE:
- After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.
  Refer to BEFORE DISCONNECTING BATTERY [05/2023 - ]
- When replacing the auxiliary battery, use a new auxiliary battery of the same dimensions and same capacity or more from the same class at a 20-hour rate.
- After replacing the auxiliary battery, install the ventilation hole plug supplied with the new battery or the ventilation hole plug from the old battery to the ventilation hole on the side to which the battery hose is not connected.
REMOVE NO. 2 DECK BOARD
Refer to PROCEDURE - Step 12

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Loosen the nut, and disconnect the cable from the negative (-) battery terminal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE BATTERY

Disengage the claw and disconnect the battery terminal cap.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Loosen the nut and disconnect the cable from the positive (+) battery terminal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 2 nuts and battery clamp sub-assembly.

Disconnect the battery exhaust hose from the auxiliary battery.

Remove the auxiliary battery.