LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Automatic Transmission System - Service Information (Coupe) (1 Of 2)) >> Forced Release >> Operation Method [03/2017 - ] >> Procedure

Operation Method [03/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. SECURE VEHICLE 
    1. Apply the parking brake.
    2. Turn the engine switch off and use wheel chocks to secure the vehicle.
      WARNING:

      During power failure, make sure use wheel chocks to secure the vehicle as the parking brake cannot be used.

  2. PARKING LOCK FORCED RELEASE 
    1. Remove the remote operation controller assembly.

      Refer to REMOVAL [03/2017 - 05/2023] , or refer to REMOVAL [05/2023 - ]

    2. While the brake pedal is depressed, use a tool to turn the hexagonal portion approximately 60° clockwise and release the parking lock.
      NOTE:
      • If excessively large amounts of torque is applied, parts may be damaged.
      • If rotated in the opposite direction, parts may be damaged.

      HINT: 

      • Torque required to release lock: Approx. 9.0 N.m (92 kgf/cm, 80 in.lbf)
      • After it is released, the hexagonal portion will return to its original position but the parking lock will stay released.
      GTY783823Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Release Parking Lock
  3. PARKING LOCK 
    1. After finishing the procedure, press the parking switch with the engine switch turned on (IG) to activate the parking lock.
scientia non olet · About LEMON Manuals