LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Supplemental Restraint System - Service Information (Coupe) (1 Of 2)) >> KNEE AIRBAG ASSEMBLY (for Driver Side) >> Removal [03/2017 - 05/2023] >> Procedure

Removal [03/2017 - 05/2023]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    WARNING:

    Be sure to read precaution thoroughly before servicing.

    Refer to PRECAUTION [03/2017 - 04/2020] , or refer to PRECAUTION [04/2020 - 05/2023]

    GTY824211Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [03/2017 - 05/2023]

  2. REMOVE NO. 2 DECK BOARD 

    Refer to PROCEDURE - Step 11 [03/2017 - 01/2021] , or refer to PROCEDURE - Step 12 [01/2021 - 05/2023]

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

    WARNING:
    • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
    • If the airbag deploys for any reason, it may cause a serious accident.
    GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [03/2017 - 04/2020] , or refer to INITIALIZATION [04/2020 - 05/2023]

  4. REMOVE REAR CONSOLE BOX POCKET 

    Refer to PROCEDURE - Step 1

  5. REMOVE RADIO REMOTE TUNING SWITCH ASSEMBLY 

    Refer to PROCEDURE - Step 2

  6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  7. REMOVE SHIFTING HOLE COVER ASSEMBLY 

    Refer to PROCEDURE - Step 4

  8. REMOVE UPPER CONSOLE BOX 

    Refer to PROCEDURE - Step 7

  9. REMOVE BOX PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 10

  10. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 10 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 10 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 10 [04/2020 - 05/2023]

  11. REMOVE FRONT DOOR OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 12 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 12 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 12 [04/2020 - 05/2023]

  12. REMOVE FRONT DOOR NO. 2 OPENING TRIM COVER LH 

    Refer to PROCEDURE - Step 14 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 14 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 14 [04/2020 - 05/2023]

  13. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 16 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 16 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 16 [04/2020 - 05/2023]

  14. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 20 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 20 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 20 [04/2020 - 05/2023]

  15. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 21 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 21 [06/2019 - 04/2020] , or refer to PROCEDURE - Step 21 [04/2020 - 05/2023]

  16. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY 
    WARNING:
    GTY819831Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    Deployment Side
    • When storing the lower No. 1 instrument panel airbag assembly, keep the airbag deployment side facing upward.
    • If the airbag deploys for any reason, it may cause a serious accident.
    1. Check that the engine switch is off.
    2. Check that the cable is disconnected from the negative (-) battery terminal.
      WARNING:
      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
      • If the airbag deploys for any reason, it may cause a serious accident.
      GTY581108Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts.
      GTY820360Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Wire Harness Clamp
    4. Detach the hooks and remove the lower No. 1 instrument panel airbag assembly.
    5. Detach the wire harness clamp.
    6. Detach the claws to disconnect the DLC3.
    7. Tilt the lower No. 1 instrument panel airbag assembly toward the seat and support it with one hand.
      GTY793373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Lock Button
      Release in this Direction
      Protective Tape
    8. Using a screwdriver, release the lock button and disconnect the airbag connector.
      NOTE:

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals