LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Exterior Panels / Trim - Service Information (Coupe) (2 Of 2)) >> Windshield Outside Moulding >> Removal [03/2017 - ] >> Procedure

Removal [03/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE ROOF DRIP SIDE FINISH MOULDING LH 
    1. Apply protective tape at the position shown in the illustration.
      GTY778950Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Using moulding remover B, detach the claws.
    3. Pull in the direction of the arrow shown in the illustration to detach the claws and remove the roof drip side finish moulding LH.
      GTY791182Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      HINT: 

      • Remove the remaining 5 No. 1 windshield outside moulding clips on the vehicle side.
      • Do not reuse the No. 1 windshield outside moulding clips.
scientia non olet · About LEMON Manuals