LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Exterior Panels / Trim - Service Information (Coupe) (2 Of 2)) >> Front Door Belt Moulding >> Removal [03/2017 - 04/2020] >> Procedure

Removal [03/2017 - 04/2020]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT DOOR TRIM COVER SUB-ASSEMBLY LH (for Driver Side) 

    Refer to PROCEDURE - Step 4 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 4 [06/2019 - 04/2020]

  2. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (for Driver Side) 

    Refer to PROCEDURE - Step 6 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 6 [06/2019 - 04/2020]

  3. REMOVE FRONT DOOR ASSIST GRIP ASSEMBLY RH (for Front Passenger Side) 

    Refer to PROCEDURE - Step 8 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 8 [06/2019 - 04/2020]

  4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH (for Front Passenger Side) 

    Refer to PROCEDURE - Step 10 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 10 [06/2019 - 04/2020]

  5. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH 

    Refer to PROCEDURE - Step 20 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 20 [06/2019 - 04/2020]

  6. REMOVE FRONT DOOR FRONT LOWER FRAME UPPER COVER LH 

    See step  6

  7. REMOVE FRONT DOOR DIVISION BAR SEAL LH 

    Refer to PROCEDURE - Step 26 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 26 [06/2019 - 04/2020]

  8. REMOVE FRONT DOOR WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 28 [03/2017 - 06/2019] , or refer to PROCEDURE - Step 28 [06/2019 - 04/2020]

  9. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH 
    1. Apply protective tape as shown in the illustration.
      GTY781746Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
      Protective Tape
    2. Using a screwdriver with its tip wrapped with protective tape, detach the guides.
    3. Detach the claws to remove front door belt moulding assembly LH.