Caution / Notice / Hint
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the active rear wing ECU removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replacement Part or Procedure | Necessary Procedure | Effect/Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative battery terminal | Memorize steering angle neutral point | Lane-keeping assist system | Refer to INITIALIZATION [03/2017 - 05/2023] |
| Pre-collision system | |||
| Parking assist monitor system | Refer to INITIALIZATION [03/2017 - 05/2023] | ||
| Steering sensor zero point calibration | Variable gear ratio steering system | Refer to INITIALIZATION [03/2017 - ] | |
| Spoiler control ECU assembly | Initialization | Active rear wing system | Refer to INITIALIZATION [03/2017 - ] |