LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 141 (Battery / Charging System - Service Information (Coupe)) >> Generator >> Removal [03/2017 - 05/2023] >> Procedure

Removal [03/2017 - 05/2023]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [03/2017 - 05/2023]

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [03/2017 - 04/2020] , or refer to INITIALIZATION [04/2020 - 05/2023]

  3. REMOVE OIL COOLER ASSEMBLY 

    Refer to REMOVAL [03/2017 - 05/2023]

  4. REMOVE FAN AND GENERATOR V BELT 

    Refer to REMOVAL [03/2017 - ]

  5. REMOVE FRONT STABILIZER BAR BRACKET BOLT 
    1. Remove the bolt and specer nut from the front frame crossmenber sub-assembly.
      GTY795503Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE GENERATOR ASSEMBLY 
    1. Detach the 2 clamps.
      GTY831773Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the bolt and disconnect the engine wire.
    3. Remove the terminal cap.
      GTY790231Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Terminal Cap
      *2 Oil Cooler Tube
      *a Bolt
      *b Nut
    4. Detach the clamp.
    5. Remove the nut and disconnect the engine wire from terminal B.
    6. Disconnect the generator assembly connector.
    7. Remove the bolt and disconnect the oil cooler tube.
    8. Remove the bolt and oil cooler bracket.
      GTY795504Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the bolt A and engine wire bracket.
      GTY838116Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Engine Wire Bracket
    10. Remove the bolt B and 2 nuts.
    11. Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.
      GTY795489Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    12. Remove the bolt and wire harness bracket from the generator assembly.
scientia non olet · About LEMON Manuals