Removal [03/2017 - 09/2023]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 13 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 13 [05/2023 - 09/2023]
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 14 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 14 [05/2023 - 09/2023]
REMOVE STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY
Refer to PROCEDURE - Step 15 [03/2017 - 05/2023] , or refer to PROCEDURE - Step 15 [05/2023 - 09/2023]

REMOVE FRONT STABILIZER LINK ASSEMBLY LH

Remove the 2 nuts and front stabilizer link assembly LH from the lower No. 2 suspension arm assembly LH and front stabilizer bar.

HINT:

If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.

REMOVE FRONT STABILIZER BAR

Remove the 4 bolts and 4 nuts, and front stabilizer bar.

HINT:

The stabilizer bracket and bush are built onto the stabilizer bar. If the bracket and/or bush detach from the bar, replace the bar.
Be careful not to drop the nuts.