Installation [09/2023 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT STABILIZER BAR

Install the front stabilizer bar with the 4 bolts and 4 nuts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf)

NOTE:

Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of (B), (C), (D), and (A).

INSTALL FRONT STABILIZER LINK ASSEMBLY LH
1. Install the front stabilizer link assembly LH to the lower No. 2 suspension arm assembly LH and front stabilizer bar with the 2 nuts.
  Torque: 125 N.m (1275 kgf/cm, 92 ft.lbf)
  
  HINT:
  
  If the ball joint turns together with the nut, use a 8 mm hexagon wrench to hold the stud bolt.
INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT:

Perform the same procedure as for the LH side.
INSTALL STRUT BAR BRACKET SUPPORT SUB-ASSEMBLY
Refer to PROCEDURE - Step 137
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 138
INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY LH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 139
INSTALL FRONT SUSPENSION MEMBER BRACE SUB-ASSEMBLY RH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 140
INSTALL FRONT FENDER SEAL LH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 18
INSTALL FRONT FENDER SEAL RH (w/ Front Suspension Member Brace)
Refer to PROCEDURE - Step 17
INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 143