Installation [03/2017 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2024 Lexus LC 500, 2023 Lexus LC 500, 2022 Lexus LC 500, 2021 Lexus LC 500, and 2020 Lexus LC 500. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL BACK-UP LIGHT ASSEMBLY
- Clean the application area of the back-up light assembly shown in the illustration.
Area to Clean - If reusing the back-up light assembly:
- Cut the 2 pieces of double-sided tape according to the dimensions shown in the illustration.
Standard Dimension
Area Dimension A 1.2 mm (0.047 in.) B 6.8 to 7.2 mm (0.268 to 0.283 in.) C 33.8 to 34.2 mm (1.331 to 1.346 in.) - Clean the installation surfaces shown in the illustration and apply the 2 pieces of double-sided tape.
Area to Clean - Remove the 2 peeling tapes from the 2 double-sided tapes.
- Cut the 2 pieces of double-sided tape according to the dimensions shown in the illustration.
- If installing a new back-up light assembly:
Remove the 2 peeling tapes from a new back-up light assembly.
- Attach the guide to set the back-up light assembly.
Screw Connector Double-sided Tape Application Area - Install the 2 screws.
- Apply pressure to the 2 pieces of double-sided tape.
- Connect the connector.
- Clean the application area of the back-up light assembly shown in the illustration.
- INSTALL REAR BUMPER ASSEMBLY
Refer to INSTALLATION [03/2017 - ]