Installation [01/2017 - ]: Procedure

1. Apply MP grease to the lip of a new rear engine oil seal.
2. Using SST and a hammer, tap in the rear engine oil seal.
   • SST: 09223-15030 
   • SST: 09950-70010 
     1. 09951-07150

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Rear Engine Oil Seal Retainer
   *a	Oil Seal Protrusion Height

   Oil Seal Protrusion Height

   -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

   NOTE:

   • Keep the lip free of foreign matter.
   • Do not tap in the rear engine oil seal at an angle.

1. Using SST, hold the crankshaft pulley.
   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Clean the 8 bolt holes.
3. Install a new 8 bolts in several steps in the sequence shown in the illustration.

   Torque: 83 N.m (846 kgf/cm, 61 ft.lbf) 

   Fig 1: Flywheel Sub-Assembly Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST, hold the crankshaft pulley.
   • SST: 09213-70011 
     1. 09213-70020
   • SST: 09330-00021 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Install the transmission input damper cover assembly to the flywheel sub-assembly with the 9 bolts. Uniformly tighten the 9 bolts in the order shown in the illustration.
   Fig 2: Transmission Input Damper Cover Assembly Bolts Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Front

   Torque: 49.4 N.m (504 kgf/cm, 36 ft.lbf) 

   NOTE:

   • Make sure that there is no oil on the transmission input damper cover assembly or flywheel sub-assembly.
   • Make sure to install the transmission input damper cover assembly in the correct direction.
   • Do not allow grease to contact the splines of the transmission input damper cover assembly or the input shaft.

Refer to INSTALLATION [01/2017 - 06/2019] , or refer to INSTALLATION [06/2019 - 04/2020] , or refer to INSTALLATION [04/2020 - 05/2023] , or refer to INSTALLATION [05/2023 - ]