LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2023 >> LC 500 2D Convertible >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Exterior Panels / Trim - Service Information (Convertible) (2 Of 2) >> Roof Drip Side Moulding >> Reassembly [07/2020 - ] >> Procedure

Reassembly [07/2020 - ]: Procedure

  1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP LH 
    1. Temporarily install the roof drip side finish moulding clip LH to the front pillar.
      GTY950373Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using an air riveter or hand riveter with a nose piece, install the roof drip side finish moulding clip LH with 2 new 4.8 mm (0.189 in.) waterproof rivets.
      NOTE:
      • Do not pry the rivet with the riveter as this will cause damage to the riveter and mandrel.
        GTY948684Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Riveter
        *b Mandrel
        *c INCORRECT
        *d CORRECT
      • Confirm that the rivets are seated properly against the roof drip side finish moulding clip LH.
        GTY948645Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Riveter
        *b INCORRECT
        *c CORRECT
      • Do not tilt the riveter when installing the rivet to the roof drip side finish moulding clip LH.
      • Do not leave any space between the rivet head and roof drip side finish moulding clip LH.
      • Do not leave any space between the roof drip side finish moulding clip LH and front pillar. Firmly hold together the 2 parts while installing the rivet.
        GTY948502Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Riveter
        *b INCORRECT
        *c CORRECT

      HINT: 

      If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

scientia non olet · About LEMON Manuals